GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-40 Section 8-3 - Control Console Components Replacement Procedures
PRELIMINARY
8-3-4 Keyboard Assembly Replacement Procedure (cont’d)
4) Loosen the two captive Allen screws on the left side, as shown in Figure 8-47 below (arrows marked
in the figure indicate the screw locations).
5) If in current use, remove the basket from the keyboard interface column (refer to “Basket Removal
Procedure” on page 8-20).
6) Tilt the keyboard assembly upwards, exposing the two cables connected to the keyboard assembly.
7) Unplug the USB cable as shown in Figure 8-47 below.
8) Using a flat screwdriver, release the two tags that secure the Data cable in position - see
Figure 8-50.
Figure 8-48 Loosening the Captive Allen Screws under Keyboard Assembly - Left Side
Figure 8-49 Disconnecting the USB Cable
To Next Page
Loading...
