GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-113
PRELIMINARY
13.)Unfasten each of the two thumbscrews on either side of the cabinet cage, as shown in Figure 8-140.
.
14.)Unfold the cage to the fully-open position, as shown in Figure 8-141.
It is now possible to gain easy access to the components inside the cabinet cage.
Figure 8-140 Cabinet Cage Thumbscrews
Figure 8-141 Cabinet Cage - Unfolded
When performing lower section component replacement procedures, an ESD wriststrap must be worn
to prevent the risk of ESD causing damage to a board.
To Next Page
Loading...
