GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-115
PRELIMINARY
Note: When closing the cage door, take care to ensure that the protective gasket (kapton strip)
surrounding the PSB (Probe Selection Board) - shown in Figure 8-143 - is properly seated
and does not become pinched or damaged.
12.)Close the two fastening latches on the left side of the cabinet cage assembly (Figure 8-130).
13) Return the front cover, as described in the 8-2-6-4 "Front Cover Installation Procedure" on page 8-
19.
14) Return the left and right side covers, as described in the 8-2-3-4 "Left Side Cover Installation
Procedure" on page 8-7 and 8-2-2-4 "Right Side Cover Installation Procedure" on page 8-5.
15.)Turn ON power to the system.
16.)Proceed to perform the following functionality tests:
- 10-6-4 "Grounding Continuity" on page 10-23
- 10-6-5 "Chassis Current Leakage Test" on page 10-24
- 7-2-4-2-1 "Calibration" on page 7-12
- 7-2-4-1 "Full System Test" on page 7-11
Figure 8-143 PSB and Surrounding Protective Strip
To Next Page
Loading...
