GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-149
PRELIMINARY
8-6-8 PSB (Probe Select Board) Board Replacement Procedure (cont’d)
5) Proceed as follows:
a.) Lift the ECG Connector up to expose the bracket, as shown in Figure 8-182.
b.) Using a flat screwdriver, carefully ease the plastic bracket from the end of the connector and
remove the bracket, as shown in Figure 8-183:
Figure 8-182 ECG Connector Exposed
Figure 8-183 Removing the Plastic Bracket
To Next Page
Loading...
