GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-154 Section 8-6 - Lower Section Components Replacement Procedures
PRELIMINARY
8-6-9 PIB (Probe Interface Board) Board Replacement Procedure (cont’d)
6.) Disconnect the flex cable from the PIB Board.
7.) Loosen and remove the five screws holding the PIB Board in position (see Figure 8-189).
NOTE: There are 3 long and 2 short screws. (The other short screw seen in Figure 8-189 is the one
removed when disconnecting the PIB-to-PSB flex cable.
8.) Remove the PIB Board from the cage assembly.
Figure 8-189 Removing the PIB Board
Figure 8-190 PIB Board Removed
To Next Page
Loading...
