GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-248 Section 8-8 - Software Loading
PRELIMINARY
8-9-5 Black and White Printer Replacement Procedure (cont’d)
5.) Using a small screwdriver, release the metal securing plate and slide it out of the compartment, as
shown in Figure 8-284 below.
6.) Disconnect the USB cable and the power cable from the rear of the Black and White Printer, as
shown in Figure 8-285.
7.) Carefully push the Black and White Printer out of the compartment, while holding it firmly to prevent
it from falling.
8.) Remove the printer and place it on a flat, stable surface.
Figure 8-283 Screws Securing Black and White Printer in Compartment
Figure 8-284 Removing the Securing Plate
Figure 8-285 Cables Disconnected from Rear of Black and White Printer
Black and White Printer
Screws this side
not visible in
illustration
To Next Page
Loading...
