GD32VF103 User Manual
505
Set by the application and cleared by USBFS.
0: Channel disabled
1: Channel enabled
Software should following the operation guide to disable or enable a channel.
Software can set this bit to disable the channel from processing transactions.
Software should follow the operation guide to disable or enable a channel.
For periodic transfers (interrupt or isochronous transfer), this bit controls that
whether in an odd frame or even frame this channel’s transaction is desired to be
processed.
0: Even frame
1: Odd frame
The address of the USB device that this channel wants to communicate with.
Must be kept at reset value
The transfer type of the endpoint that this channel wants to communicate with.
00: Control
01: Isochronous
10: Bulk
11: Interrupt
The device that this channel wants to communicate with is a Low-Speed Device.
Must be kept at reset value