Hioki 8835-01 - Page 202

180
────────────────────────────────────────────────────
8.6 Using the Analog Trigger Function
────────────────────────────────────────────────────
2. Set the trigger level.
(1) Move the flashing cursor to the position
shown in the figure on the left.
(2) Use the
JOG control or the function keys to
make the selection.
(On the DISPLAY screen, the setting cannot
be made with the
JOG control.)
: Value up, large step
: Value up, small step
: Value down, small step
: Value down, large step
3. Select the trigger direction (slope).
(1) Move the flashing cursor to the position
shown in the figure on the left.
(2) Use the function keys to make the selection.
: Enables triggering on the leading edge.
: Enables triggering on the falling edge.
4. Set the trigger filter
This setting cannot be made from the display
screen.
(1) Press the
STATUS key to call up the
STATUS 2 screen.
(2) Move the flashing cursor to the position
shown in the figure on the left.
(3) Use the
JOG control or the function keys to
make the selection.