M Bridge Control (continued)
!2 PTT-ON Tone …………… Select the DTMF signal (0 to 9, #, *) to control the radio from the SIP phone.
(Default: 0)
• Dialing the callee extension number, and then push the set button to control
the callee radio to transmit.
!3 PTT-OFF Tone …………… Select the DTMF signal (0 to 9, #, *) to control the radio from the SIP phone.
(Default: 0)
• While communicating with a radio, push the set button to control the callee
radio to receive.
When the same DTMF signal (key) is selected in [PTT-ON tone] and [PTT-
OFF Tone], each pushing PTT toggles the TX and RX.
!4 Call Control Type ………… Select the Audio Transmission Method. (Default: RTP)
• VOX: Sends the audio signal and enables the PTT, when the input audio
signal level exceeds the threshold level.
• RTP: Sends the audio signal and enables the PTT, while receiving the
RTP packet.
6
CONVERTER MODE SETTING SCREEN
6-118
9. [Port Settings] Menu
[Port Settings]–[Bridge 1–Bridge 4]
*Appears when “G.711u Signaling” is selected in the [Voice Coding] item.
!3
!4
*
*
To Next Page
Loading...
