:SEARch Commands 30
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1067
:SEARch:SERial:LIN:SYMBolic:VALue
(see page 1428)
Command Syntax
:SEARch:SERial:LIN:SYMBolic:VALue <data>
<data> ::= value in NR3 format
The :SEARch:SERial:LIN:SYMBolic:VALue command specifies the signal value to
search for when LIN symbolic data has been loaded (recalled) into the oscilloscope
and the LIN serial search mode is set to FSIGnal.
Query Syntax
:SEARch:SERial:LIN:SYMBolic:VALue?
The :SEARch:SERial:LIN:SYMBolic:VALue? query returns the specified signal value.
Return Format
<data><NL>
<data> ::= value in NR3 format
See Also • ":RECall:LDF[:STARt]" on page 718
• ":SEARch:SERial:LIN:MODE" on page 1061
• ":SEARch:SERial:LIN:SYMBolic:FRAMe" on page 1065
• ":SEARch:SERial:LIN:SYMBolic:SIGNal" on page 1066
Encoded signal values are not supported in the remote interface (even though they can be
used in the front panel graphical interface).
To Next Page
Loading...
