738 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :SAVE Commands
:SAVE:POWer[:STARt]
(see page 1428)
Command Syntax
:SAVE:POWer[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:POWer[:STARt] command saves the power measurement application's
current harmonics analysis results to a file.
See Also • "Introduction to :SAVE Commands" on page 725
• ":SAVE:FILename" on page 729
• Chapter 26, “:POWer Commands,” starting on page 619
If a file extension is provided as part of a specified <file_name>, it must be ".csv".
To Next Page
Loading...
