To Next Page

To Previous Page

536 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide

23 :MARKer Commands

:MARKer:X2Position

(see page 1610)

Command Syntax

:MARKer:X2Position <position> [suffix]

<position> ::= X2 cursor position in NR3 format

<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}

The :MARKer:X2Position command:

• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform (see

":MARKer:MODE" on page 531).

• Sets the X2 cursor position to the specified value.

X cursor units are set by the :MARKer:XUNits command.

Query Syntax

:MARKer:X2Position?

The :MARKer:X2Position? query returns current X2 cursor position. This is

functionally equivalent to the obsolete :MEASure:TSTOp command/query.

Return Format

<position> ::= X2 cursor position in NR3 format

See Also • "Introduction to :MARKer Commands" on page 529

• ":MARKer:MODE" on page 531

• ":MARKer:X1Position" on page 533

• ":MARKer:X2Y2source" on page 537

• ":MARKer:XUNits" on page 539

• ":MEASure:TSTOp" on page 1525

NOTE

If the front-panel cursors are off, the marker position values are not defined and an error is

generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in the

front-panel Normal mode.

Keysight Technologies InfiniiVision MSO-X 4154A User Manual

Questions and Answers: