:CHANnel<n> Commands 10
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 315
:CHANnel<n>:PROBe:RSENse
(see page 1428)
Command Syntax
:CHANnel<n>:PROBe:RSENse <value>
<value> ::= Ohms in NR3 format
<n> ::= 1 to (# analog channels) in NR1 format
When the N2820A high-sensitivity current probe is used with the N2825A
user-defined R-sense head, the :CHANnel<n>:PROBe:RSENse command specifies
the value of the R-sense resistor that is being probed in the device under test
(DUT).
Query Syntax
:CHANnel<n>:PROBe:RSENse?
The :CHANnel<n>:PROBe:RSENse? query returns the R-sense resistor value
setting.
Return Format
<value><NL>
<value> ::= Ohms in NR3 format
See Also • ":CHANnel<n>:PROBe:ZOOM" on page 318
• ":MEASure:DUAL:CHARge" on page 502
• ":MEASure:DUAL:VAMPlitude" on page 503
• ":MEASure:DUAL:VAVerage" on page 504
• ":MEASure:DUAL:VBASe" on page 505
• ":MEASure:DUAL:VPP" on page 506
• ":MEASure:DUAL:VRMS" on page 507
To Next Page
Loading...
