630 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:CLResponse:FREQuency:STARt
(see page 1428)
Command Syntax
:POWer:CLResponse:FREQuency:STARt <value>[suffix]
<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000}
[suffix] ::= {Hz | kHz| MHz}
The :POWer:CLResponse:FREQuency:STARt command sets the frequency sweep
start value. The control loop response analysis is displayed on a log scale Bode
plot, so you can select from decade values in addition to the minimum frequency
of 20 Hz.
Query Syntax
:POWer:CLResponse:FREQuency:STARt?
The :POWer:CLResponse:FREQuency:STARt? query returns the frequency sweep
start setting.
Return Format
<value><NL>
<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000}
See Also • ":POWer:CLResponse" on page 626
• ":POWer:CLResponse:APPLy" on page 627
• ":POWer:CLResponse:DATA" on page 628
• ":POWer:CLResponse:FREQuency:MODE" on page 629
• ":POWer:CLResponse:FREQuency:STOP" on page 631
• ":POWer:CLResponse:PPDecade" on page 632
• ":POWer:CLResponse:SOURce:INPut" on page 633
• ":POWer:CLResponse:SOURce:OUTPut" on page 634
• ":POWer:CLResponse:WGEN:LOAD" on page 635
• ":POWer:CLResponse:WGEN:VOLTage" on page 636
• ":POWer:CLResponse:WGEN:VOLTage:PROFile" on page 637
To Next Page
Loading...
