648 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:HARMonics:RPOWer
(see page 1428)
Command Syntax
:POWer:HARMonics:RPOWer <source>
<source> ::= {MEASured | USER}
When Class D is selected as the current harmonics analysis standard, the
:POWer:HARMonics:RPOWer command specifies whether the Real Power value
used for the current-per-watt measurement is measured by the oscilloscope or is
defined by the user.
When USER is selected, use the :POWer:HARMonics:RPOWer:USER command to
enter the user-defined value.
Query Syntax
:POWer:HARMonics:RPOWer?
The :POWer:HARMonics:RPOWer? query returns the Real Power source setting.
Return Format
<source><NL>
<source> ::= {MEAS | USER}
See Also • ":POWer:HARMonics:STANdard" on page 651
• ":POWer:HARMonics:RPOWer:USER" on page 649
To Next Page
Loading...
