:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 633
:POWer:CLResponse:SOURce:INPut
(see page 1428)
Command Syntax
:POWer:CLResponse:SOURce:INPut <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :POWer:CLResponse:SOURce:INPut command selects the oscilloscope
channel that is probing the power supply input.
Query Syntax
:POWer:CLResponse:SOURce:INPut?
The :POWer:CLResponse:SOURce:INPut? query returns the channel selection.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • ":POWer:CLResponse" on page 626
• ":POWer:CLResponse:APPLy" on page 627
• ":POWer:CLResponse:DATA" on page 628
• ":POWer:CLResponse:FREQuency:MODE" on page 629
• ":POWer:CLResponse:FREQuency:STARt" on page 630
• ":POWer:CLResponse:FREQuency:STOP" on page 631
• ":POWer:CLResponse:PPDecade" on page 632
• ":POWer:CLResponse:SOURce:OUTPut" on page 634
• ":POWer:CLResponse:WGEN:LOAD" on page 635
• ":POWer:CLResponse:WGEN:VOLTage" on page 636
• ":POWer:CLResponse:WGEN:VOLTage:PROFile" on page 637
To Next Page
Loading...
