836 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger:EVENt:AUToset
(see page 1428)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:AUToset
The :SBUS<n>:FLEXray:TRIGger:EVENt:AUToset command automatically
configures oscilloscope settings (as shown on the display) for the selected event
trigger.
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE" on page 838
• ":SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID" on page 837
• ":SBUS<n>:FLEXray:TRIGger" on page 834
• ":SBUS<n>:FLEXray:BAUDrate" on page 827
• ":TRIGger[:EDGE]:LEVel" on page 1166
• ":SBUS<n>:FLEXray:SOURce" on page 833
To Next Page
Loading...
