1278 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:ARBitrary:DATA:DAC
(see page 1428)
Command Syntax
:WGEN<w>:ARBitrary:DATA:DAC {<binary> | <value>, <value> ...}
<w> ::= 1 or 2 in NR1 format
<binary> ::= decimal 16-bit integer values between -512 to +511
in IEEE 488.2 binary block format
<value> ::= decimal integer values between -512 to +511
in comma-separated NR1 format
The :WGEN<w>:ARBitrary:DATA:DAC command downloads an arbitrary waveform
using 16-bit integer (DAC) values.
See Also • ":WGEN<w>:ARBitrary:DATA" on page 1275
• ":SAVE:ARBitrary[:STARt]" on page 727
• ":RECall:ARBitrary[:STARt]" on page 715
To Next Page
Loading...
