Keysight Technologies InfiniiVision MSO-X 4154A

:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 901
:SBUS<n>:SENT:CRC
(see page 1428)
Command Syntax
:SBUS<n>:SENT:CRC <format>
<format> ::= {LEGacy | RECommended}
The :SBUS<n>:SENT:CRC command specifies the format of the CRC. Either
Legacy (2008) or Recommended (2010).
Enhanced Serial Message CRCs are always calculated using the 2010 format, but
for the Fast Channel Messages, and for Short Serial Message CRCs, this setting is
used.
Query Syntax
:SBUS<n>:SENT:CRC?
The :SBUS<n>:SENT:CRC? query returns the CRC format setting.
Return Format
<format><NL>
<format> ::= {LEG | REC}
See Also • ":SBUS<n>:SENT:CLOCk" on page 900
• ":SBUS<n>:SENT:DISPlay" on page 902
• ":SBUS<n>:SENT:FORMat" on page 904
• ":SBUS<n>:SENT:IDLE" on page 906
• ":SBUS<n>:SENT:LENGth" on page 907
• ":SBUS<n>:SENT:PPULse" on page 908
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 909
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 910
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 912
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 913
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 914
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 916
• ":SBUS<n>:SENT:SOURce" on page 918
• ":SBUS<n>:SENT:TOLerance" on page 920
• ":SBUS<n>:SENT:TRIGger" on page 921
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 923
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 924
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 926
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 928
• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 929