372 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
15 :DISPlay Commands
:DISPlay:LABList
(see page 1428)
Command Syntax
:DISPlay:LABList <binary block data>
<binary block> ::= an ordered list of up to 75 labels, a maximum of 10
characters each, separated by newline characters.
The :DISPlay:LABList command adds labels to the label list. Labels are added in
alphabetical order.
Query Syntax
:DISPlay:LABList?
The :DISPlay:LABList? query returns the label list.
Return Format
<binary block><NL>
<binary block> ::= an ordered list of up to 75 labels, a maximum of 10
characters each, separated by newline characters.
See Also • "Introduction to :DISPlay Commands" on page 360
• ":DISPlay:LABel" on page 371
• ":CHANnel<n>:LABel" on page 309
• ":DIGital<d>:LABel" on page 354
• ":BUS<n>:LABel" on page 286
Labels that begin with the same alphabetic base string followed by decimal digits are
considered duplicate labels. Duplicate labels are not added to the label list. For example, if
label "A0" is in the list and you try to add a new label called "A123456789", the new label is
not added.
To Next Page
Loading...
