:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 655
:POWer:INRush:EXIT
(see page 1428)
Command Syntax
:POWer:INRush:EXIT
The :POWer:INRush:EXIT command exits (stops) the inrush current power analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:INRush:APPLy" on page 654
• ":POWer:INRush:NEXT" on page 656
• ":POWer:ITYPe" on page 657
To Next Page
Loading...
