696 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:SIGNals:VSTeady:ONOFf:ON
(see page 1428)
Command Syntax
:POWer:SIGNals:VSTeady:ONOFf:ON <value>[suffix]
<value> ::= Expected steady state output Voltage value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VSTeady:ONOFf:ON command specifies the expected steady
state output DC voltage of the power supply for turn on analysis.
Query Syntax
:POWer:SIGNals:VSTeady:ONOFf:ON?
The :POWer:SIGNals:VSTeady:ONOFf:ON query returns the expected steady state
voltage setting.
Return Format
<value><NL>
<value> ::= Expected steady state output Voltage value in NR3 format
See Also • ":POWer:ONOFf:APPLy" on page 661
• ":POWer:SIGNals:AUTosetup" on page 681
• ":POWer:SIGNals:DURation:ONOFf:ON" on page 687
• ":POWer:SIGNals:IEXPected" on page 690
• ":POWer:SIGNals:OVERshoot" on page 691
• ":POWer:SIGNals:VMAXimum:ONOFf:ON" on page 694
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 698
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 699
To Next Page
Loading...
