Obsolete and Discontinued Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1361
:MEASure:TSTOp
(see page 1428)
Command Syntax
:MEASure:TSTOp <value> [suffix]
<value> ::= time at the stop marker in seconds
[suffix] ::= {s | ms | us | ns | ps}
The :MEASure:TSTOp command moves the stop marker (X2 cursor) to the
specified time with respect to the trigger time.
Query Syntax
:MEASure:TSTOp?
The :MEASure:TSTOp? query returns the time at the stop marker (X2 cursor).
Return Format
<value><NL>
<value> ::= time at the stop marker in NR3 format
See Also • "Introduction to :MARKer Commands" on page 453
• "Introduction to :MEASure Commands" on page 488
• ":MARKer:X1Position" on page 457
• ":MARKer:X2Position" on page 460
• ":MARKer:XDELta" on page 462
• ":MEASure:TDELta" on page 1356
• ":MEASure:TSTArt" on page 1360
The short form of this command, TSTO, does not follow the defined Long Form to Short Form
Truncation Rules (see page 1430). The normal short form "TST" would be the same for both
TSTArt and TSTOp, so sending TST for the TSTOp command produces an error.
The :MEASure:TSTOp command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:X2Position command (see page 460) instead.
To Next Page
Loading...
