888 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal
(see page 1428)
Command Syntax
:SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal <name>
<name> ::= quoted ASCII string
The :SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal command specifies the signal to
trigger on when LIN symbolic data has been loaded (recalled) into the oscilloscope
and the LIN trigger mode is set to FSIGnal.
Query Syntax
:SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal?
The :SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal? query returns the specified signal.
Return Format
<name><NL>
<name> ::= quoted ASCII string
See Also • ":RECall:LDF[:STARt]" on page 718
• ":SBUS<n>:LIN:TRIGger" on page 881
• ":SBUS<n>:LIN:TRIGger:SYMBolic:FRAMe" on page 887
• ":SBUS<n>:LIN:TRIGger:SYMBolic:VALue" on page 889
To Next Page
Loading...
