:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 663
:POWer:ONOFf:NEXT
(see page 1428)
Command Syntax
:POWer:ONOFf:NEXT
The :POWer:ONOFf:NEXT command goes to the next step of the turn on/turn off
analysis.
This command is equivalent to pressing the Next softkey on the oscilloscope front
panel when prompted during the analysis.
See Also • ":POWer:ONOFf:THResholds" on page 665
• ":POWer:ITYPe" on page 657
• ":POWer:ONOFf:APPLy" on page 661
• ":POWer:ONOFf:EXIT" on page 662
• ":POWer:ONOFf:TEST" on page 664
To Next Page
Loading...
