:TRIGger Commands 33
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1155
:TRIGger:DELay:TRIGger:COUNt
(see page 1428)
Command Syntax
:TRIGger:DELay:TRIGger:COUNt <count>
<count> ::= integer in NR1 format
The :TRIGger:DELay:TRIGger:COUNt command sets the Nth edge of the trigger
source to trigger on.
Query Syntax
:TRIGger:DELay:TRIGger:COUNt?
The :TRIGger:DELay:TRIGger:COUNt? query returns the current Nth trigger edge
setting.
Return Format
<count><NL>
<count> ::= integer in NR1 format
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":TRIGger:DELay:TRIGger:SLOPe" on page 1156
• ":TRIGger:DELay:TRIGger:SOURce" on page 1157
• ":TRIGger:DELay:TDELay:TIME" on page 1154
To Next Page
Loading...
