:MEASure Power Commands 23
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 569
:MEASure:OPOWer
(see page 1428)
Command Syntax
:MEASure:OPOWer
The :MEASure:OPOWer command installs an output power measurement on
screen.
Before sending this command or query, you must specify the channels probing the
input voltage, input current, output voltage, and output current (using the
:POWer:SIGNals:SOURce:VOLTage<i> and :POWer:SIGNals:SOURce:CURRent<i>
commands) and you must perform the automated signals setup (using the
:POWer:SIGNals:AUTosetup EFFiciency command).
Query Syntax
:MEASure:OPOWer?
The :MEASure:OPOWer query returns the measured output power.
Return Format
<return_value><NL>
<return_value> ::= the output power value in NR3 format
See Also • ":POWer:SIGNals:SOURce:VOLTage<i>" on page 699
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 698
• ":POWer:SIGNals:AUTosetup" on page 681
• ":POWer:EFFiciency:APPLy" on page 639
To Next Page
Loading...
