712 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:TRANsient:NEXT
(see page 1428)
Command Syntax
:POWer:TRANsient:NEXT
The :POWer:TRANsient:NEXT command goes to the next step of the transient
analysis.
This command is equivalent to pressing the Next softkey on the oscilloscope front
panel when prompted during the analysis.
See Also • ":POWer:TRANsient:APPLy" on page 708
• ":POWer:TRANsient:EXIT" on page 709
• ":POWer:TRANsient:IINitial" on page 710
• ":POWer:TRANsient:INEW" on page 711
To Next Page
Loading...
