:WGEN<w> Commands 35
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1309
:WGEN<w>:TRACk:AMPLitude
(see page 1428)
Command Syntax
:WGEN<w>:TRACk:AMPLitude <on_off>
<w> ::= 1 or 2 in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:TRACk:AMPLitude ON command causes amplitude and offset
adjustments to this waveform generator output signal to be tracked by the other
waveform generator output.
Also, when tracking is enabled, adjustments for tracked settings in the other
waveform generator become unavailable (ghosted).
Query Syntax
:WGEN<w>:TRACk:AMPLitude?
The :WGEN<w>:TRACk:AMPLitude? query returns whether amplitude tracking is
on or off.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • ":WGEN<w>:TRACk" on page 1308
• ":WGEN<w>:TRACk:FREQuency" on page 1311
• ":WGEN<w>:TRACk:PHASe" on page 1312
• ":WGEN<w>:TRACk:CSIGnal" on page 1310
To Next Page
Loading...
