Keysight Technologies InfiniiVision MSO-X 4154A

:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 815
:SBUS<n>:CXPI:TRIGger:IDFilter
(see page 1428)
Command Syntax
:SBUS<n>:CXPI:TRIGger:IDFilter {{0 | OFF} | {1 | ON}}
When triggering on CRC Field Errors, Inter-Byte Space Errors, Framing Errors, or
Data Length Errors, the :SBUS<n>:CXPI:TRIGger:IDFilter command lets you
enable/disable modification of the trigger so that it occurs only for a specified ID.
Query Syntax
:SBUS<n>:CXPI:TRIGger:IDFilter?
The :SBUS<n>:CXPI:TRIGger:IDFilter? query returns the ID filter setting.
Return Format
<setting><NL>
<setting> ::= {0 | 1}
See Also • ":SBUS<n>:CXPI:TRIGger" on page 813
• ":SBUS<n>:CXPI:TRIGger:PTYPe" on page 816
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA" on page 817
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA:LENGth" on page 818
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt" on page 819
• ":SBUS<n>:CXPI:TRIGger:PATTern:ID" on page 820
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:CT" on page 821
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:DLC" on page 822
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:NM" on page 823