Keysight Technologies InfiniiVision MSO-X 4154A

1366 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
37 Obsolete and Discontinued Commands
:MEASure:VSTOp
(see page 1428)
Command Syntax
:MEASure:VSTOp <vstop_argument>
<vstop_argument> ::= value for Y2 cursor
The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to the
specified value corresponding to the selected source. The source can be selected
by the MARKer:X2Y2source command.
Query Syntax
:MEASure:VSTOp?
The :MEASure:VSTOp? query returns the current value of the Y2 cursor.
Return Format
<value><NL>
<value> ::= value of the Y2 cursor in NR3 format
See Also • "Introduction to :MARKer Commands" on page 453
• "Introduction to :MEASure Commands" on page 488
• ":MARKer:Y1Position" on page 466
• ":MARKer:Y2Position" on page 468
• ":MARKer:YDELta" on page 469
• ":MARKer:X2Y2source" on page 461
• ":MEASure:SOURce" on page 529
• ":MEASure:TDELta" on page 1356
• ":MEASure:TSTArt" on page 1360
NOTE
The short form of this command, VSTO, does not follow the defined Long Form to Short Form
Truncation Rules (see page 1430). The normal short form, VST, would be the same for both
VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.
NOTE
The :MEASure:VSTOp command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:Y2Position command (see page 468) instead.