286 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
8 :BUS<n> Commands
:BUS<n>:LABel
(see page 1428)
Command Syntax
:BUS<n>:LABel <quoted_string>
<quoted_string> ::= any series of 10 or less characters as a
quoted ASCII string.
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:LABel command sets the bus label to the quoted string. Setting a
label for a bus will also result in the name being added to the label list.
Query Syntax
:BUS<n>:LABel?
The :BUS<n>:LABel? query returns the name of the specified bus.
Return Format
<quoted_string><NL>
<quoted_string> ::= any series of 10 or less characters as a
quoted ASCII string.
See Also • "Introduction to :BUS<n> Commands" on page 280
• ":BUS<n>:BIT<m>" on page 281
• ":BUS<n>:BITS" on page 282
• ":BUS<n>:CLEar" on page 284
• ":BUS<n>:DISPlay" on page 285
• ":BUS<n>:MASK" on page 287
• ":CHANnel<n>:LABel" on page 309
• ":DISPlay:LABList" on page 372
• ":DIGital<d>:LABel" on page 354
Example Code
' Set the bus 1 label to "Data":
myScope.WriteString ":BUS1:LABel 'Data'"
This command is only valid for the MSO models.
Label strings are 10 characters or less, and may contain any commonly used ASCII characters.
Labels with more than 10 characters are truncated to 10 characters.
To Next Page
Loading...
