54 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
1 What's New
Changed
Commands
:SBUS<n>:LIN:TRIGger:SYMBol
ic:VALue (see page 991)
Specifies signal value to trigger on when LIN symbolic data has
been loaded (recalled) into the oscilloscope and the LIN trigger
mode is set to FSIGnal.
:SEARch:SERial:LIN:SYMBolic:F
RAMe (see page 1221)
Specifies the message to search for when LIN symbolic data has
been loaded (recalled) into the oscilloscope and the LIN serial
search mode is set to FRAMe or FSIGnal.
:SEARch:SERial:LIN:SYMBolic:
SIGNal (see page 1222)
Specifies signal to search for when LIN symbolic data has been
loaded (recalled) into the oscilloscope and the LIN serial search
mode is set to FSIGnal.
:SEARch:SERial:LIN:SYMBolic:
VALue (see page 1223)
Specifies signal value to search for when LIN symbolic data has
been loaded (recalled) into the oscilloscope and the LIN serial
search mode is set to FSIGnal.
:WGEN<w>:OUTPut:MODE (see
page 1467)
Specifies whether the defined waveform is output continuously or
as a single cycle (single-shot).
:WGEN<w>:OUTPut:SINGle
(see page 1469)
When the single-shot output mode is selected, this command
causes a single cycle of the defined waveform to be output.
Command Description
Command Differences
:SBUS<n>:LIN:TRIGger (see
page 982)
You can now trigger on symbolic frames (with parameter FRAMe)
or frames and signal values (with parameter FSIGnal).
:SEARch:SERial:LIN:MODE (see
page 1217)
You can now search for symbolic messages (with parameter
FRAMe) or frames and signal values (with parameter FSIGnal).
To Next Page
Loading...
Need help?
General
