746 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :SAVE Commands
:SAVE[:SETup[:STARt]]
(see page 1428)
Command Syntax
:SAVE[:SETup[:STARt]] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE[:SETup[:STARt]] command saves an oscilloscope setup.
See Also • "Introduction to :SAVE Commands" on page 725
• ":SAVE:FILename" on page 729
• ":SAVE:PWD" on page 739
• ":RECall:SETup[:STARt]" on page 721
If a file extension is provided as part of a specified <file_name>, it must be ".scp".
To Next Page
Loading...
