:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 691
:POWer:SIGNals:OVERshoot
(see page 1428)
Command Syntax
:POWer:SIGNals:OVERshoot
<percent>
<percent> ::= percent of overshoot value in NR1 format
The :POWer:SIGNals:OVERshoot command specifies the percent of overshoot of
the output voltage. This value is used to determine the settling band value for the
transient response and to adjust the vertical scale of the oscilloscope.
Query Syntax
:POWer:SIGNals:OVERshoot?
The :POWer:SIGNals:OVERshoot query returns the overshoot percent setting.
Return Format
<percent><NL>
<percent> ::= percent of overshoot value in NR1 format
See Also • ":POWer:TRANsient:APPLy" on page 708
• ":POWer:SIGNals:AUTosetup" on page 681
• ":POWer:SIGNals:DURation:TRANsient" on page 689
• ":POWer:SIGNals:IEXPected" on page 690
• ":POWer:SIGNals:VSTeady:TRANsient" on page 697
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 698
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 699
To Next Page
Loading...
