Keysight Technologies InfiniiVision MSO-X 4154A

Obsolete and Discontinued Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1379
:SBUS<n>:SPI:SOURce:DATA
(see page 1428)
Command Syntax
:SBUS<n>:SPI:SOURce:DATA <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:SPI:SOURce:DATA command sets the source for the SPI serial
MOSI data.
This command is the same as the :SBUS<n>:SPI:SOURce:MOSI command.
Query Syntax
:SBUS<n>:SPI:SOURce:DATA?
The :SBUS<n>:SPI:SOURce:DATA? query returns the current source for the SPI
serial MOSI data.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":SBUS<n>:SPI:SOURce:MOSI" on page 939
• ":SBUS<n>:SPI:SOURce:MISO" on page 938
• ":SBUS<n>:SPI:SOURce:CLOCk" on page 936
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 937
• ":SBUS<n>:SPI:TRIGger:PATTern:MISO:DATA" on page 940
• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA" on page 942
• ":SBUS<n>:SPI:TRIGger:PATTern:MISO:WIDTh" on page 941
• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh" on page 943