To Next Page

To Previous Page

:DIGital<d> Commands 15

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 395

:DIGital<d>:DISPlay

(see page 1610)

Command Syntax

:DIGital<d>:DISPlay <display>

<d> ::= 0 to (# digital channels - 1) in NR1 format

<display> ::= {{1 | ON} | {0 | OFF}}

The :DIGital<d>:DISPlay command turns digital display on or off for the specified

channel.

Query Syntax

:DIGital<d>:DISPlay?

The :DIGital<d>:DISPlay? query returns the current digital display setting for the

specified channel.

Return Format

<display> ::= {0 | 1}

See Also • "Introduction to :DIGital<d> Commands" on page 394

• ":POD<n>:DISPlay" on page 701

• ":CHANnel<n>:DISPlay" on page 349

• ":VIEW" on page 297

• ":BLANk" on page 266

• ":STATus" on page 294

NOTE

This command is only valid for the MSO models.

Keysight Technologies InfiniiVision MSO-X 4154A User Manual

Questions and Answers: