Keysight Technologies InfiniiVision MSO-X 4154A

916 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:SENT:SIGNal<s>:STARt
(see page 1428)
Command Syntax
:SBUS<n>:SENT:SIGNal<s>:STARt <position>
<s> ::= 1-6, in NR1 format.
<position> ::= from 0-23, in NR1 format.
The :SBUS<n>:SENT:SIGNal<s>:STARt command specifies the starting bit of the
Fast Signal being defined.
Fast Signal definition examples:
Query Syntax
:SBUS<n>:SENT:SIGNal<s>:STARt?
The :SBUS<n>:SENT:SIGNal<s>:STARt? query returns the Fast Signal starting bit
setting.
Return Format
<position><NL>
<position> ::= from 0-23, in NR1 format.
See Also • ":SBUS<n>:SENT:CLOCk" on page 900
• ":SBUS<n>:SENT:CRC" on page 901
• ":SBUS<n>:SENT:DISPlay" on page 902
• ":SBUS<n>:SENT:FORMat" on page 904
• ":SBUS<n>:SENT:IDLE" on page 906
• ":SBUS<n>:SENT:LENGth" on page 907
• ":SBUS<n>:SENT:PPULse" on page 908
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 909
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 910