Status Reporting 39
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1399
Example The following example uses the resource session object's ReadSTB method to read
the contents of the oscilloscope's Status Byte Register.
varQueryResult = myScope.IO.ReadSTB
MsgBox "Status Byte Register, Serial Poll: 0x" + Hex(varQueryResult)
Use Serial Polling to Read Status Byte Register. Serial polling is the preferred method to read
the contents of the Status Byte Register because it resets bit 6 and allows the next enabled
event that occurs to generate a new SRQ interrupt.
To Next Page
Loading...
