Obsolete and Discontinued Commands 39
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1535
:MTESt:LOAD
(see page 1610)
Command Syntax
:MTESt:LOAD "<filename>"
The :MTESt:LOAD command loads the specified mask file.
The <filename> parameter is an MS-DOS compatible name of the file, a maximum
of 254 characters long (including the path name, if used).
See Also • "Introduction to :MTESt Commands" on page 667
• ":MTESt:AMASk:{SAVE | STORe}" on page 1532
The :MTESt:LOAD command is obsolete and is provided for backward compatibility to previous
oscilloscopes. Use the :RECall:MASK[:STARt] command (see page 816) instead.
To Next Page
Loading...
Need help?
General
