Keysight Technologies InfiniiVision MSO-X 4154A

430 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
19 :HARDcopy Commands
Introduction to
:HARDcopy
Commands
The HARDcopy subsystem provides commands to set and query the selection of
hardcopy device and formatting options such as inclusion of instrument settings
(FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this case, the
query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
:HARDcopy:NETWork:PAS
Sword <password> (see
page 440)
n/a <password> ::= quoted ASCII
string
:HARDcopy:NETWork:SLO
T <slot> (see
page 441)
:HARDcopy:NETWork:SLO
T? (see page 441)
<slot> ::= {NET0 | NET1}
:HARDcopy:NETWork:USE
Rname <username> (see
page 442)
:HARDcopy:NETWork:USE
Rname? (see page 442)
<username> ::= quoted ASCII
string
:HARDcopy:PALette
<palette> (see
page 443)
:HARDcopy:PALette?
(see page 443)
<palette> ::= {COLor | GRAYscale
| NONE}
n/a :HARDcopy:PRINter:LIS
T? (see page 444)
<list> ::= [<printer_spec>] ...
[printer_spec>]
<printer_spec> ::=
"<index>,<active>,<name>;"
<index> ::= integer index of
printer
<active> ::= {Y | N}
<name> ::= name of printer
:HARDcopy:STARt (see
page 445)
n/a n/a
Table 102 :HARDcopy Commands Summary (continued)
Command Query Options and Query Returns