What's New 1
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 47
Changed
Commands
:SAVE:RESults:FORMat:CURSo
r (see page 741)
Specifies whether cursor values will be included when analysis
results are saved.
:SAVE:RESults:FORMat:MASK
(see page 742)
Specifies whether mask statistics will be included when analysis
results are saved.
:SAVE:RESults:FORMat:MEASu
rement (see page 743)
Specifies whether measurement results will be included when
analysis results are saved.
:SAVE:RESults:FORMat:SEARc
h (see page 744)
Specifies whether found search event times will be included when
analysis results are saved.
:SAVE:RESults:FORMat:SEGMe
nted (see page 745)
Specifies whether segmented memory acquisition times will be
included when analysis results are saved.
:SEARch:PEAK Commands (see
page 1009)
Commands to set up searching for FFT peaks.
:SBUS<n>:CAN:COUNt:SPEC
(see page 783)
Returns the count for the number of Spec errors (Ack + Form +
Stuff + CRC errors).
:SBUS<n>:CAN:FDSPoint (see
page 787)
Sets the CAN FD sample point.
:SBUS<n>:CAN:SIGNal:FDBaud
rate (see page 792)
Sets the CAN FD baud rate.
:SBUS<n>:CAN:TRIGger:IDFilte
r (see page 797)
Specifies, in certain error and bit trigger modes, whether triggers
are filtered by CAN IDs.
:SBUS<n>:CAN:TRIGger:PATTer
n:DATA:DLC (see page 799)
Specifies the DLC value to be used in the CAN FD data trigger
mode.
:SBUS<n>:CAN:TRIGger:PATTer
n:DATA:STARt (see page 801)
Specifies the starting byte position for CAN FD data triggers.
:SBUS<n>:SENT Commands
(see page 897)
Commands for using the SENT triggering and serial decode
feature.
:SEARch:SERial:SENT
Commands (see page 1072)
Commands for searching SENT serial decode events.
:WGEN<w>:TRACk:PHASe (see
page 1312)
Sets the phase relationship of a frequency-tracked waveform
generator output.
Command Description
Command Differences
:DEMO:FUNCtion (see
page 344)
The DCMotor, HARMonics, COUPling, CFD, and SENT functions
are now available with the DSOXEDK educator's kit license.
To Next Page
Loading...
