Keysight Technologies InfiniiVision MSO-X 4154A

:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 759
:SBUS<n>:MODE
(see page 1428)
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {A429 | FLEXray | CAN | CXPI | I2S | IIC | LIN | M1553
| SENT | SPI | UART | USB}
The :SBUS<n>:MODE command determines the decode mode for the serial bus.
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode setting.
Return Format
<mode><NL>
<mode> ::= {A429 | FLEX | CAN | CXPI | I2S | IIC | LIN | M1553 | SENT
| SPI | UART | USB | NONE}
Errors • "-241, Hardware missing" on page 1387
See Also • "Introduction to :SBUS<n> Commands" on page 755
• ":SBUS<n>:A429 Commands" on page 760
• ":SBUS<n>:CAN Commands" on page 777
• ":SBUS<n>:FLEXray Commands" on page 824
• ":SBUS<n>:I2S Commands" on page 843
• ":SBUS<n>:IIC Commands" on page 862
• ":SBUS<n>:LIN Commands" on page 872
• ":SBUS<n>:M1553 Commands" on page 890
• ":SBUS<n>:SENT Commands" on page 897
• ":SBUS<n>:SPI Commands" on page 930
• ":SBUS<n>:UART Commands" on page 946
• ":SBUS<n>:USB Commands" on page 968
NOTE
This command is only valid when a serial decode option has been licensed.