856 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:DISPlay
(see page 1610)
Command Syntax
:SBUS<n>:DISPlay <display>
<display> ::= {{1 | ON} | {0 | OFF}}
The :SBUS<n>:DISPlay command turns displaying of the serial decode bus on or
off.
Query Syntax
:SBUS<n>:DISPlay?
The :SBUS<n>:DISPlay? query returns the current display setting of the serial
decode bus.
Return Format
<display><NL>
<display> ::= {0 | 1}
Errors • "-241, Hardware missing" on page 1551
See Also • "Introduction to :SBUS<n> Commands" on page 853
• ":CHANnel<n>:DISPlay" on page 349
• ":DIGital<d>:DISPlay" on page 395
• ":POD<n>:DISPlay" on page 701
• ":VIEW" on page 297
• ":BLANk" on page 266
• ":STATus" on page 294
This command is only valid when a serial decode option has been licensed.
Two I2S buses or two SPI buses cannot be decoded on both SBUS1 and SBUS2 at the same
time.
To Next Page
Loading...
Need help?
General
