248 Matrix ETERNITY NE System Manual
Configuring Matrix SPARSH VP110 Open SIP Phone
You are recommended to complete the following steps before connecting the Matrix SPARSH VP110 Open SIP
Phone:
• Decide the physical location of the Open SIP Phone.
• Log into Jeeves as the System Engineer.
• Configure “DHCP Server” of SARVAM UCS in the “Network Parameters”. The DHCP Server of SARVAM
UCS will be used for assigning the ‘Auto Provisioning Server Address’ and ‘Server Port’ to the Open SIP
Phone.
If you are using third party DHCP Server in your LAN, see “Using any third party DHCP Server in your
LAN”.
SIP Port
Enter the port on which the phone will listen for SIP
messages. This port is used as source port in SIP
messages.This port is also used to send SIP
messages to the remote peer. Default: 5060
Htek 802 IP Phone
Min RTP Port
To define a range of RTP ports, configure the
minimum local RTP port. Default: 11780
Htek 802 IP Phone
Max RTP Port
To define a range of RTP ports, configure the
maximum local RTP port. Default: 11800
Htek 802 IP Phone
Apply System
Time Zone
Select this check box if you want to apply the
System’s Time Zone to the Open SIP Phone.
Htek 802 IP Phone
Time Zone
Select the Time Zone of the region/country where the
Open SIP Phone is installed. Default: GMT + 05:30
Htek 802 IP Phone
Primary NTP
Server
Select the Primary NTP Server Address with which
you want to synchronize the Date and Time of the
Open SIP Phone. Default: None. Make sure you
configure the desired NTP Server Address/es in the
“Third Party IP-Phone General Parameters”.
Htek 802 IP Phone
Daylight Saving
Time Mode
Select the Daylight Saving Time Mode that should be
applied to the selected Open SIP Phone. Default:
Automatic.
Htek 802 IP Phone
a. If the phone is in the same network (LAN) as SARVAM UCS, select Use LAN Port IP Address as Registrar Server Address.
If the phone is in the Global Network and SARVAM UCS is connected to Internet over WAN, select Use WAN Port IP
Address as Registrar Server Address
If the phone is connected in the Global Network and SARVAM UCS is located behind a NAT Router, and STUN is pro-
grammed, select Use Router/STUN's IP Address as Registrar Server Address. Make sure the Router’s Public IP Address is
configured in the Network Parameters.
If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as Registrar Server
Address.
b. To avoid unauthorized access, we recommend you to change the Admin Password regularly. Make sure it is
strong and is kept confidential.
To Next Page
Loading...
