Keys
No. Key type Function
1 Stop key Press the red key left of the display to stop the copy process
for the current original. You can stop the original transport im-
mediately when an original jam occurs.
2 Section keys The section keys are the four keys located above the display.
These keys provide access to the ‘Custom’, ‘Original’, ‘Print’
and “File’ sections on the display. Each section contains sever-
al functions (cards). These can be accessed with the help of
the function key all the way to the left, which is also called the
card selection key.
3 Arrow keys Like the numeric keys, the arrow keys can be used to define
numeric settings. The arrow keys are also used for selecting
subfunctions.
4 Correction key The orange key marked with C is located at the bottom of the
central section of the operator panel. Press the correction key
one time to reset the selected setting to its default value. Press
the correction key two times to reset the numeric display to
‘1’. Press the correction key three times to return to the first
screen on the display.
5 Numeric keys The keys with numbers on the lower part of the operator panel
are used to enter numbers.
6 Start key The green key marked with is used to start the feeding of the
original, or to restart the copy process.
7 Function keys The five function keys (below the display) allow you to select
functions or subfunctions within a card.
8 Job interrupt
key
Use the job interrupt key to set extra priority to your copy job
or to remove extra priority from your copy job. Determine the
priority of your copy job with the Job interrupt key before you
scan your originals. The job is placed at the top of the sched-
uled jobs in the controller application. The interrupt job will
start running directly after the current page is completed. No
new job is sent to the printer.
Océ TDS600 Scanner operator panel
Chapter 2 - Introduction
37
To Next Page
Loading...
Need help?
General