Configure the scan destinations
Configure scan destinations
Introduction
When you select the [Scan] tab on the user panel a list of scan destinations is displayed.
A scan destination is a place where you send your scanned file to for storage.
You can define a maximum number of 10 scan destinations in the [Configuration] - [Scan
destinations] tab.
Illustration
First set the general settings:
1. Open the [Configuration] - [Scan destinations] tab
2. In the [Generic] section, in case you use the FTP protocol for scan-to-file to remote destination,
define the [Encoding for remote FTP servers].
3. View the status of [Scan to local destinations allowed]. When the [Smart Inbox capability] is
enabled, the scanned files are stored in the Smart Inbox. When the [Smart Inbox capability] is
disabled, the scanned files cannot be stored locally on the controller.
Types of scan destinations
You can scan-to-file to 2 different scan destination types.
Configure the scan destinations
Chapter 3 - Define your workflow with Océ Express WebTools
139
To Next Page
Loading...
