Secure protocols
IPv6 settings
Introduction
In case IPv6 is enabled:
• You can see all IPv6 information in the [Configuration] - [Overview] tab
• If IPv6 is enabled, the System Administrator or Power User can change some of the IPv6
settings.[Connectivity]
IPv6 settings
The following settings are available for IPv6:
[IPv6 Link Local address]
This address is determined automatically. you
cannot change them.
[IPv6 Stateless (SLAAC) address] This address is determined automatically. you
cannot change them.
[Enable IPv6 address configuration by DHCP] The IPv6 DNS address can be provided by the
DHCP server when a DHCP server is available.
If not, enter the address manually.
[IPv6 manual address] the IPv6 address when set manually. Enter the
value “::” or “0:0:0:0:0:0:0:0” to disable a man-
ual IPv6 address.
[IPv6 Gateway by DHCP] It is recommended not to check it. Enter the
Gateway address manually.
[IPv6 default gateway address] Fill it in to set the IPv6 default Gateway ad-
dress.
[Enable IPv6 DNS configuration by DHCP] The IPv6 DNS address can be provided by the
DHCP server when a DHCP server is available.
[IPv6 address of DNS server] It is automatically set when the DHCP server is
available and enabled. If the DHCP server is
not enabled, the IPv6 address of the DNS serv-
er can be set manually. Then enter the IPv6 ad-
dress of the DNS server manually.
Secure protocols
Chapter 3 - Define your workflow with Océ Express WebTools
87
To Next Page
Loading...
Need help?
General