Special copy and scan jobs
On the TDS600 scanner you can carry out a number of special tasks in order to perform special
copy or scan jobs.
These include:
• Non-standard size originals
Non-standard size originals (Océ TDS600 scanner)
on page 260
• The scan width
The scan width
on page 261
• The copy size
The copy size
on page 262
• Scanning originals with filing strip
Scanning originals with filing strip - Copying with removed
filing strip along the left hand side
on page 263
• Brightness
Brightness
on page 269
• Automatic background compensation
Automatic background compensation
on page 270
• Original type:
Original type
on page 271
• Auto align
Auto align
on page 272
• Shift the image
Shift the image
on page 274
• Mirror image
Mirror image
on page 275
• Make a set copy
Make a set copy
on page 276
Non-standard size originals (Océ TDS600 scanner)
The Océ TDS600 scanner automatically detects the width of the inserted original. For DIN sizes,
for example, it detects whether the width is A0, A1, A2, A3, A4, 500 mm, or 700 mm.
The Océ TDS600 scanner system uses a memory table that contains all standard width - standard
length combinations to predict the length of the original. The scanner also measures the real
length of each original while it is transferred through the scanner.
NOTE
When you scan thick, thin or damaged originals or originals in a carrier sheet, use of output at
the rear side of the scanner is recommended to ensure correct delivery.
Special copy and scan jobs
260
Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs
To Next Page
Loading...
Need help?
General