Load the settings from a file
Purpose
Load the settings and the values for the Océ Express WebTools from a file.
When to do
• Duplicate the settings to another printer of the same type.
IMPORTANT
When you are logged in as a Key operator you can only load the Key operator settings. When
you are logged in as a System administrator you can only load the System administrator
settings. To load all the settings that are stored in the file you must log in as a Power user.
NOTE
Not all settings are stored in the settings file. The network settings are excluded from the file
because the network settings cannot be duplicated to another printer. The passwords for
authorized users and the passwords for remote scan destinations are excluded from the file for
security reasons. License information is not included in the file either.
Procedure
1.
Click the [Configuration] tab or the [Preferences] tab.
2.
Click [Open set] in the top-right hand corner of the screen. A secondary window is opened.
3.
Navigate to the location of the settings file and select the file.
4.
Click [Ok] to load the settings file or [Cancel] to close the window without loading the settings file.
Result
The values of the settings in the settings file overwrite the current values. The network
configuration settings of the system and the passwords are not restored to prevent connectivity
problems and to guarantee the integrity of the passwords.
Load the settings from a file
76
Chapter 3 - Define your workflow with Océ Express WebTools
To Next Page
Loading...
Need help?
General